How To Install A Couch Turf?

 

Planning to install a couch turf? These grasses have a good drought tolerance and require less maintenance. However, they perform best when fertilized regularly. Simply put there are many benefits of installing a couch turf.

With this comes to mind the expenses, installation, maintenance and much more. Wondering how to install a couch turf? Here is what you need to know.

Guide to Installation of a Couch Turf

Wondering how to install a couch turf Sydney? Here are simple yet best steps to follow :

Step 1: Ground Preparation

The very first thing you need to check before the installation of couch turf in Sydney is to prepare the ground. For larger areas, a bobcat can be used to level the ground; for smaller sections like residential yards, a metal hand rake can be used.

Step 2: Remove Unwanted Particles

To guarantee a good-looking turf, make sure to remove any rocks, debris, or irregularities in the ground as you level the surface. This will also make it much simpler to mow your new lawn. Make sure to lay on a 50 to 100 mm-thick bed of superior turf underlay.

Step 3: Top Soil Preparation

Before laying any turf or empire zoysia in Sydney, topsoil or turf underlay may need to be installed if your soil is deficient in organic matter. If topsoil is needed, it should be spread out to a thickness of 100mm, or four inches.

For every 25 square metres of lawn, approximately two tonnes of topsoil or turf underlay soil are required. For best results, you should opt for professionals to help you with turf installation. Also after your ground preparation is done and you want to install an underground irrigation system, then now is the time.

Step 4: Lay the Edges

Be it empire zoysia in Sydney or any turf, this step involves laying them down. Starting at one edge, such as a building wall or fence, begin laying turf and work your way to the point where it ends, such as a footpath, a roadside curb, or the edge of a driveway.

This method of laying the turf tends to lessen the trampling of the turf during installation, such as by wheelbarrows and foot traffic. However, keep the rows close together when you roll out your turf since spaces allow weeds to develop.

Step 5: Fill the Gaps

You will ultimately reach a point when you must make cuts to close gaps. For simpler cutting, start by cutting from the turf roll's underside using a Stanley knife. Make sure the small patches of the lawn shouldn't be inserted along the edges because they tend to dry up, which causes problems with the establishment.

Instead, spread turf to the full width on all edges and place your smaller in-fill pieces in between two full rows.

Step 6: Go Through your Work and Water

After you finish your job, check the entire area for any flaws. Now the last step is to water. The water must reach the ground below the roll at the very least. Every day, lift the turf to check for moisture under the rolls to see if the turf is moist.

You might need to water your plants twice a day for a few weeks in the spring or summer. Besides, you might only need to water every three or four days in the fall. However, until you can no longer lift the roll up, keep checking the moisture level.